Last Modified: 11-29-2007 1.6 A
Service Category: Engine/Hybrid System Section: Engine Mechanical
Model Year: 2008 Model: Sequoia Doc ID: RM000002BRI00GX
Title: 2UZ-FE ENGINE MECHANICAL: REAR CRANKSHAFT OIL SEAL: INSTALLATION (2008 Sequoia)

INSTALLATION

1. INSTALL REAR CRANKSHAFT OIL SEAL

(a) Apply MP grease to the lip of a new oil seal.

(b) Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

SST: 09223-56010

NOTICE:

  • Keep the lip free from foreign matter.
  • Do not tap on the oil seal at an angle.

2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY 2UZ-FE ENGINE MECHANICAL: ENGINE ASSEMBLY: INSTALLATION (2008 Sequoia)+

3. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY (for 2WD)

(a) Install the automatic transmission assembly A750E AUTOMATIC TRANSMISSION / TRANSAXLE: AUTOMATIC TRANSMISSION ASSEMBLY: INSTALLATION (2008 Sequoia) .

4. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY (for 4WD)

(a) Install the automatic transmission assembly A750F AUTOMATIC TRANSMISSION / TRANSAXLE: AUTOMATIC TRANSMISSION ASSEMBLY: INSTALLATION (2008 Sequoia) .

5. INSPECT FOR OIL LEAK 2UZ-FE LUBRICATION: OIL AND OIL FILTER: REPLACEMENT (2008 Sequoia)+

6. INSPECT FOR COOLANT LEAK 2UZ-FE COOLING: COOLING SYSTEM: ON-VEHICLE INSPECTION (2008 Sequoia)+

7. INSPECT FOR AUTOMATIC TRANSAXLE FLUID LEAK

8. INSTALL NO. 1 ENGINE UNDER COVER 2UZ-FE LUBRICATION: OIL AND OIL FILTER: REPLACEMENT (2008 Sequoia)+